Lg H818N Dead Boot ,Hard bricked Recovery flash file / firmware mistakenly flashed the Modem+Boot+Bootloader+Rom Phone Got Dead 100% tested Solution Mega link to get dump Model Supported H815 H818 H818N H818P H819 LS995 LS991 H811 1. Download QPST.WIN.2.7-00430-GENERAL Run setup.exe Windows [Start] button >> Allprograms >> QPST >> QFIL installation confirmation 2. Download Qdload9008_HSUSB_Driver Install Drivers 3. D / L via QFIL To force QDloader download mode, connect the FORCED_USB emmc section with a jumper. Or pressing key combination (volup + voldown) and poweron to boot Emergency D / L mode After two points in the red circle are shorted and connected by power or USB connection, Qdloadmode can be entered and connected to QFIL In Emergency D / L mode, check the port in Device Manager after connecting USB -> QS Windows [Start] button >> All programs >> QPST >> Run QFIL Select Port 1. Click the "Select Port" button If you deselect Show Non Diagnostic Port, only the "Diagnostic" or "QDLoader" port will be visible Selecting the port identified by Device Manager MBN file selection 2. Click the "Browse" button Select the file "prog_emmc_firehose_8992_lite_stable.mbn" in the folder where the images are stored. For fusing samples, use images made for fusing. ForFusingDevice: For Fusing Devices -> Download to LAF after recovery NotForFusingDevice: for non-fused devices -> Restore and download Select Build, RawProgram, Patch Check Check RawProgram and Patch settings Check the rawprogram0.xmlpatch0.xml file included in the -Select Build path. firehoseprogrammer MBN selected in the same folder Rawprogram0.xml, patch0.xml are loaded. SWDownload 4. Click the "Download" button - The progress bar below is completed and the Download Succeed -> Finish Download message is confirmed.